Advantages and disadvantages of vibrating screen

The manufacturing process of wire woven mesh, punched plate mesh and electroformed mesh is different. The following machine will compare the advantages and disadvantages of the three kinds of vibrating screens in the detailed use of the three vibrating screens.

The cost is relatively low, the flexibility is very good, but the square aperture formed by the staggered wire teeth, so the mesh shape is fixed, and the mesh accuracy is relatively the lowest among the three kinds of screens (the mesh is from 2.36 mm to 0.02 mm). Between the two, and under the impact of the accumulation of material, the mesh may be deformed.
This type of screen is widely used in large-volume vibrating screen equipment such as industrial production. For laboratory vibrating screens with high precision requirements, it is often used for small-sized occupations or for diamond occupations, especially for export manufacturers. The negative difference, due to the difference between foreign and China, is more than 90% of the total grain, such as 230 is better between 75 microns and 63 microns.
Therefore, the punching machine directly punches the whole steel plate, and the mesh hole of the punching plate has the characteristics of uniform precision and not easy to be deformed, and the mesh shape also has two kinds of round holes and square holes. However, the mesh accuracy is still not very precise (from 0.2 to several hundred millimeters), so the punching plate is often used for screening materials with large specific gravity, large impact on the screen or large particles of the laboratory. Detection.